Placing A Single Original Document - Epson GT-30000 User Manual

To load documents into the ADF, follow these steps:
1. Slide the edge guide all the way out.
2. Insert the document stack face up into the ADF until it meets resistance. Then
move the right edge guide so it is flush with the right edge of your document.
3. Continue with the scanning procedure on page 58.

Placing a Single Original Document

Follow these steps to position a single page:
1. Raise the ADF and place your
document face down on the
document table.
2. Position the document so the
horizontal and vertical edges are
carefully aligned with the scales on
the top and left side of the
document table.
3. Close the ADF slowly. Be careful
not to move the document.
top corner of
document
57
How to Scan