Draytek VIGOR 3300 User Manual page 44

Host Name
Domain Name
Detect Type
Detect Interval (sec)
No-Reply Count
Detect Destination Host
(IP or Domain Name)
IP Alias List
Apply
Reset
40
Some ISP may ask you to type your host name. Please type in if
necessary.
Some ISP may ask you to type your domain name. Please type
in if necessary.
Select a detecting type for this WAN interface. There are three
ways Send ARP to Gateway, Send PING and Send HTTP
Request supported in 3300.
Assign an interval period of time for each detecting. The
minimum value is 3 and no limit for maximum value.
Assign detecting times to ensure the connection of the WAN.
After passing the times you set in this field and no reply
received by the router, the connection of WAN interface will be
regarded as breaking down.
Assign an IP address or Domain name as a destination to be
detected whether the host is active (sending reply to the
router) or not. If not, the connection of WAN interface will be
regarded as breaking down. This function is available when
Detect Type is set with Send PING or Send Http Request.
Sets other IP addresses binding in this interface. You can set up
to 32 sets of IP alias settings. If you have typed addresses here,
you can see and choose it in later web page settings (e.g.,
Advanced >> NAT>>Port Redirection/DMZ Host).
Click Apply to go back to the WAN Interface Configuration
page. To apply all settings, click Apply on the WAN Interface
Configuration page and reboot your router.
Click this button to clear all the configurations for this page.
Vigor3300 Series User's Guide