Draytek VIGOR 3300 User Manual page 42

Edit
IP Mode
Active
Default Route
Load Balance
Weight
Backup-Master
Backup-Slave
VoIP
Most users will use their routers primarily for Internet access. The Vigor3300 Series supports
broadband Internet access and provides multiple WAN interfaces. The following sections will
give a detailed illustration to broadband access methods.
Click the "Edit" icon to bring up the WAN configuration page for the corresponding interface.
Default MAC
User Defined MAC
Downstream Rate
Upstream Rate
Type
Physical Mode
38
Open the configuration page of this WAN interface.
Displays current mode of this WAN interface. There are five options:
Static, DHCP, PPPoE, PPTP and DHCP.
Activates/closes this WAN interface.
Sets this WAN interface as default route interface.
Adds this WAN interface to the load balance group.
Sets the weight load (10-90%) for this WAN interface for load balance.
This selection is available only when Auto Weight is unchecked.
Sets this WAN interface as a master interface. WAN1 must be assigned
as Master interface if Backup function is enabled.
Sets this WAN interface as a slave interface.
Sets this WAN interface as VoIP default interface.
Uses the default Mac address.
Uses a MAC address defined by users. If you select this item, you
have to type the MAC address in the box below.
Sets downstream rate for this WAN interface. The default value is
102400 kbps (100 Megabit).
Sets transmission rate for this WAN interface. The default value is
102400 kbps (100 Megabit).
Sets connection type for this WAN interface.
Sets connection speed mode. There are five options including Auto
negotiation, full duplex, half duplex, 10M and 100M.
Vigor3300 Series User's Guide