Star Micronics LC-6211 User Manual page 41

Problem
Printer test works, but printer
will not print out data from
the attached computer.
Printer does not feed paper
properly.
Line spacing is incorrect.
Printer makes excessive
noise.
Possible Cause
Your application program's or
system software's printer
selection is wrong.
The computer's system
software is not set up
properly for the printer or for
the type of interface cable
you are using.
The interface cable is
connected incorrectly or
damaged.
Jamming paper.
The printer is not set up
correctly for the thickness of
paper being used.
Jamming paper.
The line spacing or leading
selected your application
program is wrong.
Auto line feed with carriage
return is enabled by the EDS
setting.
The front cover is removed.
The printer is vibrating.
Recommended Action
Check the printer selection
of your application software.
Check the system software
settings.
Check to make sure that the
printer interface cable is
connected correctly. If it is,
try a different cable.
Remove all paper from the
printer and then reload it.
Set up the printer for the
paper thickness you are
using. See "Adjusting for
paper thickness" on page 26.
Set up the printer for the
paper thickness you are
using. See "Adjusting for
paper thickness" on page 26.
Choose a different line
spacing or leading setting
from your application.
Use the EDS Mode to
disable auto line feed with
carriage return. See "Auto
LF with CR" on page 22.
Replace the front cover.
Move any objects that are
touching the printer.
Make sure that the printer is
on a level steady surface.
35