Entering The Eds Mode - Star Micronics LC-6211 User Manual

Entering the EDS Mode

Turn off the printer.
Make sure that paper is loaded in the printer.
While holding down the control panel's SET/EJECT/PARK button, turn
the printer back on.
This causes the following message to be printed.
Note:
The paper is not fed after the message is printed, so you will have to open up
the printer's front cover to read it.
Press SET/EJECT/PARK to answer "Yes" or LINE FEED to answer
"No" for each option as it appears on the printout. Each time you reply,
printer prints the next setting.
To jump to the next category at any time, press ON LINE.
After you are finished making the EDS settings you want, hold down ON
LINE and press LINE FEED.
This exits the EDS Mode and registers all of the changes you have made.
Entering the EDS Mode 21