Table of Contents
Advertisement
Before Running EPSETUP
Before using EPSETUP to install Ethernet Card as a remote
printer, you must do the following:
Decide which Novell print server the Ethernet Card will operate
1.
under. (The Ethernet Card must be installed under a Novell
print server running PSERVER.)
2.
Enter PCONSOLE.
3.
Select "Print Server Information," and choose
you are installing the Ethernet Card under.
4.
Select
Configuration."
5.
Press
6.
In
the
Parallel, LPT1."
Press
Select "Queues Serviced by Printer" from the "Print Server
Configuration" menu.
Assign a queue to the print server port.
10. Exit PCONSOLE and reboot the print server.
Running EPSETUP
1. Make sure that the Ethernet Cards host printer is turned on and
that the Ethernet Card is connected to the network.
2.
Log into the network with supervisor privilege.
3.
From the network or local drive where you copied the Ethernet
Card utilities, enter EPSETUP.
1-8
Installing the Ethernet Card
Server Configuration," then "Printer
"Print
to select
ENTER
"Printer # Configuration" screen, choose "Remote
save changes, then press
ESC to
Ethernet Cards LPT1 port.
the
print server
the
again.
ESC
Advertisement
Table of Contents
