Before Setting Up; Installing The Ethernet Card As A Print Server - Epson C82324* User Manual

Use EPSETUP for your initial Ethernet Card setup. After setting
Ethernet Card up on at least one file server, you can use either
the
EPSETUP or PCONSOLE, to configure the Ethernet Card to
service queues on other file servers. If you
using EPSETUP, press F1 for on-line help.
while

Before setting up

Read Terms and Concepts in the Introduction.
Decide whether you
server or as a remote printer. If you need more information, see
the Introduction.
Install the Ethernet Card and connect it to the network, following
the instructions earlier in this chapter. The Ethernet Card must
be connected to the network and the host printer must be
turned
on
At a workstation with a high-density floppy drive, use the DOS
COPY command (copy a:*.*) to copy utilities from the Ethernet
Card diskette to a network directory or to your hard drive.

Installing the Ethernet Card as a Print Server

This section describes installing the Ethernet Card as a print
server using EPSETUP. You can configure a number of
parameters using EPSETUP, either during or after installation.
For detailed instructions on configuring specific items
EPSETUP, see Chapter 2.
Follow these steps to install the Ethernet Card as a print server.
1. Make sure that the Ethernet Cards
and that the interface is connected to the network.
2. Log in to the network with supervisor privilege.
want to
before setting up.
use the Ethernet Card as a print
host
Installing the Ethernet Card
have questions
with
printer is turned
on
1-5