Table of Contents
Advertisement
5.
Create the Ethernet Card print server on the new file server.
Select:
Print Server Information,
Press INSERT,
Enter the Ethernet Card print server name. (Give it the
same name as on the master file server.)
6.
Configure print server ports. Select:
Print Server Information,
Print Server Configuration,
Printer Configuration.
Do not change the default Type.
Select Printer 0.
7. Assign print queues to the print server port. Select:
Print Server Information,
Print Server Configuration,
Queues Serviced by Printer. Select LPTl.
Press
8.
Authorize the print server to service the queues. Select:
Print
Queue Servers.
Candidates.
9.
Exit PCONSOLE. Reset the Ethernet Card using EPSETUP,
using EPCONFIG serial-number N=E RESET, or do it
manually by turning the host printer off and then back on.
Note:
If you want to avoid resetting, in PCONSOLE select Print Server
Information. if you have not already done so, add your login name as a
print server operator Then select Print Server Status/Control, and make
all the changes described in steps 3-8 under Print Server Status/Control.
3-10 Troubleshooting
to display available queues.
INSERT
Queue Information,
Press INSERT
to display Queue Server
Advertisement
Table of Contents
