Table of Contents
Advertisement
About your projector
Remote control
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(16)
Attention
z Do not drop the remote control.
z Avoid contact with liquids or moisture.
z Do not attempt to modify or disassemble the remote control.
z When strap is attached to the remote control, do not fling the remote control while holding the strap.
Note
z The remote control can be used within a distance of about 15 m (49'2") if pointed directly at the remote control
receiver. The remote control can control at angles of up to ±15° vertically and ±30° horizontally, but the effective
control range may be reduced.
z If there are any obstacles between the remote control and the remote control signal receptor, the remote
control may not operate properly.
z The signal will be reflected off the screen. However, the operating range may differ due to the screen material.
z If the remote control signal receptor receives strong light such as fluorescent light directly, the remote control
may not operate properly. Use it in a place distant from the light source.
(1) Remote control indicator
(15)
Flashes by pressing any buttons.
(2) Power
button
Sets the projector to the standby mode when the <MAIN POWER> switch on the
projector is set to <ON>. Starts projection when the projector power is off and in the
standby mode.
(3) Input selection (<COMPUTER>, <COMPONENT>, <VIDEO/S-VIDEO>, and <HDMI
1/2>) buttons
Switches the input signal to project. (
Used to set the ID number of the remote control and a security password. (
(10)
(4) <MENU> button
Displays the main menu screen. (
(5) <FREEZE> button
Used to temporarily freeze the image and turn off sound. (
(6) <DEFAULT> button
Restores the contents of the sub-menu to the factory default setting. (
(7) <FUNC1> to <FUNC3> buttons
Assigns a frequently used operation and use as a shortcut button. (
(11)
(8) <ID SET> button
Sets the ID number of the remote control when the system uses multiple projectors.
(
page 24)
(12)
(9) <ID ALL> button
Simultaneously controls all the projectors with one remote control when the system uses
(13)
multiple projectors. (
(10) <AUTO SETUP> button
Automatically adjusts [SHIFT], [DOT CLOCK], and [CLOCK PHASE] when computer
(14)
signal is input.
(11) ▲▼◀▶ buttons/<RETURN> button/<ENTER> button
Used to operate the menu screen.
Also used to enter the password for [SECURITY] or to enter characters.
(12) <AV MUTE> button
Used to temporarily turn off the image and sound. (
(13) <ECO> button
Displays the setting screen for the ECO management. (
(14) <VOLUME +>/<VOLUME - > button
Adjusts the volume of the audio output. (
(15) Remote control signal transmitter
(16) Strap hole
Attach a strap onto the remote control for your convenience.
About your projector
page 42)
page 44)
page 24)
page 43)
page 24)
page 41)
page 45)
page 43)
page 41)
page 43)
ENGLISH - 21
Advertisement
Table of Contents
