Table of Contents
Advertisement
Maintenance/replacement
13) Press the power
video projection.
14) Press the <MENU> button to display the menu screen and then press ▲▼ to select
[PROJECTOR SETUP].
15) Press the <ENTER> button and then press ▲▼ to select [LAMP RUNTIME].
16) Hold the <ENTER> button for approximately three seconds.
▶
z The [LAMP RUNTIME] confirmation message is displayed.
17) Press ◀▶ to select [OK], and press the <ENTER> button.
▶
z The lamp usage time (converted value) is reset to 0 and the power is turned off. After a short while, the
projector enters the standby mode.
■ Attaching the top cover
▶
Hold the top cover as shown in the following figure, align the hinge with the support,
and while pushing the arm in the direction of the arrow (towards the inner side of the
projector), push it into the groove.
106 - ENGLISH
button on the control panel or on the remote control to start
LAMP RUNTIME
LAMP RUNTIME RESET.
OK
Arm
Support
Hinge
Groove
CANCEL
Advertisement
Table of Contents
