Assembly; Check Blade Insert; Adjusting Blade Insert - Craftsman 113.221720 Owner's Manual

assembly
Bag of Loose Parts
Containing the following:
Q Key, Switch ................................................... 1
R Nut, Square 1/4-20 ........................................ 2
S Screw, Soc. Set 1/4x 7/8 ........................ ...... 4
T Washer, Flat 17/64 x 9/16 x 3/64 .................. 4
U Lockwasher, External 1/4 .............................. 4
U Lockwasher, External #8 ............................... 2
V Nut, Hex 1/4-20 ............................................. 2
W Screw, Truss Hd. 1/4-20 x 5/8 ....................... 2
X Screw, Pan Hd. 8-32 x 3/8 ............................ 2
Y Screw, Flat Hd. 1/4-20 x 5/8 ........................ 14
_Q
V
%w
mNSTALUNG HANDWHEELS
1. From among the loose parts, find the following hard-
ware:
* 2 Lockwasher, External #8
* 2 Screw, Pan Cross 8-32 x 3/8
2 Handwheels
Items marked with an asterisk (*) are shown actual size.
EXTERNAL
LOCKWASHER, NO. 8
PAN CROSS SCREW
8-32 X 3/8
HANDWHEEL
2. install Elevation Hahdwheel onto elevation shaft by
lining up FLAT on shaft with flat inside Handwheel.
install screw and Iockwasher.
3. install Bevel Handwheelonto bevel shaft by lining up
FLAT on shaft with fiat inside handwheel, install
screw and Iockwasher.
CAUTION: Failure to complete the foflowing two
steps could result _n damage to your saw.
4. Turn Bevel Handwheel counterclockwise to pull
motor away from inner packing styrofoam.
5. Remove styrofoam.
LOCKWASHER.
REMOVEPACKING MATERIAL
FROM UNDERNEATH MOTOR
LOCKWASHER
SCREW
CHECK BLADE INSERT
1. rum saw over.
2. Check blade insert to make sure it is flush with table.
If blade insert is satisfactory, proceed to "Checking
Heeling or Parallelism of Sawbiade to Miter Gauge
Groove". If insert is not flush, go on to "Adjusting
Blade Insert".
CAUTION: insert must be even with the table J
surface. An insert higher than the table top can
I
"snag" the front edge of the workpiece, making it
harder to safely feed the work into the blade.
I II