Wiring Diagram - Craftsman 113.221720 Owner's Manual

lubrication
The saw motor bearings have been packed at the factory
with proper lubricant and require no additional lubrica-
tion.
The following parts should be oiled occasionally with
SAE No. 20 or No. 30 engine oil.
1. Elevation guide slot and pivot,
2. Elevation screw threads and support bearings.
3. Bevel screw threads and support bearings. (First
clean with Craftsman Gum & Pitch Remover.)
4. Bevel and elevation link pivot points.
5. Cradle pivot pin bearing points.
6. Bearing points in Miter Gauge and Rip Fence.
The saw table and other major parts are made of
aluminum and require no special care. A coat of auto-
mobile-type wax applied to the table will help to keep the
surface clean and allow workpieces to slide more freely.
Treat unplated and unpainted steel parts and surfaces
with Sears "Stop Rust".
MITER GAUGE
GUARD
BEARING PARTS
SUPPORT
SEARiNGS
wiring diagram
BEVEL LINK SUPPORT
BEARINGS
BEVEL NUT
O
T BLACK
WIRE
CONNECTOR
TGREEN
WHITEBLACK "_POWER CORD
39