Craftsman 113.221720 Owner's Manual page 19

2. Parts are assembled as shown in illustration. Follow
steps below.
3. MAKE SURE TH E BLADE IS ALL THE WAY UP AND
SQUARE WITH THE TABLE.
SQUARE NUT
_..,_ , _=./ SPREADER SUPPORT
TRUSS HEAD _, _ SPREADER BRACKET
SCREW I
5/8 IN. LONG _"__/_ _ SPREADER CLAMP
SOCKETHEAD _ _'/
SETSCREW _---__ 8 "_, _ I WING NUT
7/8 iN. LONG "'_ "_o_J /,
w AS.E. tt
HEX NuT "-"_ _ LOCKWASHER
EXT. 1/4 IN.
BLADE SQUARE
4. Position Spreader Support on rod with end even with
end of rod.
WITH TABLE
"O BE EVEN WiTH
END OF ROD
5. Assemble the7/8 in longset screws, nuts,iockwashers
and washers to the Spreader Support Bracket and
slip the nuts into theslot in the Spreader Support.
6. Finger tighten ONLY THE HEX NUTS.
NOTE: Be sure to put the socket head set screwthrough
the slot shaped holes in the Spreader Bracket (see
illustration). This allows the guard and spreader to be
lined up with the blade. Be sure the socket end of the
setscrew is at the hex nut end of the assembly.
HEAD
SETSCREW
"m
FLAT
WASHER _
LOCKWASHER _
HEX NUT _
,. L ayap,eoeo,,, s, ra,0ht.o an a__oo,
saw table and rotate the Spreader Support until the
bracket is aligned with square,
Using an 1/8 inch Hex 'L' wrench, tighten the set °
screws only. Check that Spreader Support cannot be
rotated on the Spreader Rod.
/
TIGHTEN
SETSCREW ONLY
!9
/