Adjusting Bevel Pointer - Craftsman 113.221720 Owner's Manual

ADJUSTING 90 ° BEVEL STOP
1. On the stop bracket are two 10-32 pan head screws
which set 90 ° stop position. If condition A exists, the
two screws need to be turned clockwise to obtain 90=
setting. If condition B exits, the screws should be
turned counterclockwise.
/BLADE
_t
tl
It
II
2. Turn saw over.
3. Rotate bevel crank until blade is in approximately 40 °
bevel position and using phillips screwdriver, rotate
screws slightly in direction necessary to correct gap,
(rotate screws equally). Recheck blade position and
readjust if necessary.
4. When 90 ° stop position is adjusted to your satisfac-
tion, re-adjust pointer to 0° position.
/BLADE
I
I
I
I I
Ir
ti
BEVEL
STOP BRACKET
BEVEL .A T \
BEVEL ADJUSTING
SCREWS
BEVEL
HANDWHEEL
1
....... ! _
ADJUSTING BEVEL POINTER
Using a pair long nose pliers, carefully bend the Bevel
Pointer so that it points to the "0" mark.
_---3 f
r
I
®
I
13