Craftsman 113.221720 Owner's Manual page 22

6. Move the measuring tape under head of Rip Fence
untilthe 10 inch mark on the measuring tape is lined
up with the right edge of the Rip Fence head.
RiP FENCE H__
\ 11
7_ Hold the measuring tape in this position with one
hand, while using the other hand to peel off approxi-
mately one inch of protective coating from underside
of tape on the left end ("0" inch).
"O" INCH
9. Carefully, so as not to disturb measuring tape, unlock
Rip Fence and remove from saw.
PEEL OFF X_
r APPROX. 1 IN.
/ \
PRESS TAPE
INTO
10. Carefully raise the rest of the measuring tape, and
peel off the rest of the protective coating.
12. Place Rip Fence on saw table on the left side of the
blade.
REST OF
COATING
22