Transducer Setting - Furuno FCV-1100L Installation Manual

Transducer setting

Change the terminal board setting at the rear of the display unit according to the transducer
connected.
Note the alphabet which appeared when selecting the transducer type on the installation
main menu (page 3-4), and then do the following procedures.
1. Dismount the display unit from the mounting place.
2. Loosen four screws to remove the rear cover.
Note: There is no gasket for lid. (The groove around the terminal board does not hold a
gasket.)
3. Fasten the crimp-on lug to the appropriate terminal according to alphabet appearing on
the installation menu.
4. Remount the display unit.
Loosen these screws.
Display unit, rear view
L
A B C D E
TB10 TB9 TB8 TB7 TB6
For High Frequency
For Low Frequency
Terminal board
12-24_VDC
NMEA
TEMP
H
L
H
A B C D E
TB5 TB4 TB2 TB1
TB3
3. INITIAL SETTINGS
3-5