Unpacking - Craftsman 320.23465 Operator's Manual

Do not restart a cutting operation in the workpiece. To resume a cutting
operation: while keeping the tool from contacting the workpiece, allow the
tool reach full speed and then carefully guide the cutting accessory into the
cut.
• Keep your hands away from the cutting area. Do not reach under the material
being cut.
• Hold power tools by their insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal parts of the tool "live" and
shock the operator.
1,WARNING: Wear ear protection. Exposure to noise can cause hearing
loss.
_, WARNING: To avoid injury, hold the tool by the insulated gripping surfaces
only. If the tool contacts hidden wiring or its own cord, exposed metal parts
of the tool could shock the operator and cause serious injury. Make sure that
hidden electrical wiring, water pipes, or other hazards are not in the cutting path.
_, WARNING: Your Multi-Tool should never be connected to the power
source when you are assembling parts, making adjustments, installing
or removing blades, cleaning, or when it is not in use. Disconnecting the
Multi-Tool will prevent accidental starting, which could cause serious
personal injury.
When unpacking the box, do not discard any packing materials until all of
the contents are accounted for:
1. Carefully lift the Multi-Tool out of the carton and place on a stable, flat
surface.
2. Open the color box to locate the following:
• Multi-Tool
• Circular Saw Blade
• Flush Cut Blade
• Carbide Triangular rasp
• Carbide Circular Blade
• Scraper Blade
• Sanding Base Plate
• 9 pieces Sandpaper (3pieces each of 60, 120, 180 grit )
• Hex Key
23465 ManuaLRevised_10 0705 Page 9