Craftsman 320.23465 Operator's Manual page 20

4. Fig. 19
Align the grooves on the
carbide circular blade with
the four raised ribs on the
drive shaft; put the carbide
circular blade onto the drive
shaft. (Fig. 19)
5.
With your gloved hand
holding the carbide circular
blade, put on and tighten
the flange bolt using the hex
key.
NOTE: The ribs on the
shaft and the grooves in the
accessory tools permit a firm
connection of the accessory
tools in increments of 30 °
around the shaft (Fig. 20).
Apply the accessory tool in the
orientation appropriate to the
task at hand.
Fig. 20
//_
w_/
23465 ManuaLRevised_lO 0705 Page 20