Craftsman 320.23465 Operator's Manual page 26

4.
5.
Align the grooves on the
flush-cut blade with the
four raised ribs on the drive
shaft; put the blade onto the
drive shaft. (Fig. 36)
With your gloved hand
holding the blade, put on
and tighten the flange bolt
using the hex key.
NOTE: The ribs on the
shaft and the grooves in the
accessory tools permit a firm
connection of the accessory
tools in increments of 30 °
around the shaft (Fig. 37).
Apply the accessory tool in the
orientation appropriate to the
task at hand.
USING THE FLUSH CUT
BLADE (Fig. 38)
1.
2.
3.
4.
5.
Connect the Multi-Tool to a
power source.
Clamp the workpiece
securely.
Draw the cutting lines on
the workpiece.
Put the blade along the line.
Switch on the tool, and
apply with appropriate
pressure until the blade
cuts to the depth needed
according to the scale on
the blade.
Fig. 36
Figl 37 .... " ,
7
Fig. 38
Multi-Tool Accessories Available Separately
Craftsman Sandpaper kit (17374)
Craftsman Detail Cutting Blade (17375)
Craftsman Rough Cut Blade (17376)
Check at sears.com or your Craftsman retailer for additional accessories.
23465 ManuaLRevised_lO 0705 Page 26