To Store The Table Saw Accessories; To Move The Leg Stand; To Remove/Replace The Throat Plate - Craftsman 315.218061 Operator's Manual

TO STORE THE TABLE SAW ACCESSORIES
See Figures 8 - 9.
The table saw has two convenient storage areas (one on
either side of the saw cabinet) specifically designed for
the saw's accessories.
When not in use, store the accessories securely by snap-
ping each accessory in place.
BLADE
WRENCHES
MITER
FENCE
STORAGE
HOOK
Fig. 8
TO MOVE THE LEG STAND
See Figure 10.
To move the leg stand:
[] Holding the leg stand firmly, pull the leg stand toward
you until the leg stand and saw are balanced on the
wheels.
[] Push the saw to the desired location then either open
the leg stand for immediate saw operation or store the
saw in a dry environment.
"qL
Fig. 10
TO REMOVE/REPLACE THE THROAT PLATE
See Figure 11.
[] Lower the blade by turning the height/bevel adjusting
handwheel counterclockwise.
[] Loosen the screws in the throat plate.
[] Lift the throat plate from the saw.
[] To reinstall the throat plate, align the holes in the throat
plate with the holes in the saw table.
[] Retighten the screws, being careful not to overtighten,
which can cause the throat plate to bow or bend.
NOTE: Securely tighten throat plate screws. Do not al-
low the throat plate to bow up above the table surface.
RiP
FENCE
SAW
TABLE
oSCREW
THROAT
Fig. 9
17
Fig. 11