Table of Contents
Advertisement
MOUNTING SAW TO LEG STAND
See Figure 10.
,_
WARNING:
Firmly bolt the saw to the leg stand
to keep the saw from tipping, walking, or sliding.
•
Locate the following hardware from a small hard-
ware bag:
4 hex bolts (5/16-18 x 5/8 in.)
4 Iockwashers (5/16 in.)
8 flat washers (11/32 in.)
4 hex nuts (5/16-18)
•
Place the saw on top of the leg stand so the holes
in the saw base line up with the holes on top of the
leg stand braces.
•
Put a washer on a screw, and put the screw and
washer into the hole in the saw base. Cap with
another washer, then a Iockwasher and a hex nut.
Hand tighten the set.
•
Install the other three sets and securely tighten all
four sets with a 1/2 in. wrench.
ATTACHING
ELEVATING
HANDWHEEL
See Figure 11.
,_
WARNING:
Be sure the main power cord of
your saw is unplugged. Ignoring this precaution
could result in serious injury. Do not perform the
following steps unless the saw is unplugged.
The elevating handwheel adjusts the height of the
radial arm and the blade.
•
Take the handwheel, star washer, and screw
(10-24 x 5/8 in. Soc. Hd.) from the hardware bag.
•
Place the handwheel on the end of the elevating
shaft, which extends from the front of the saw base.
•
Place the star washer on the screw and thread
screw into the end of the shaft.
•
Securely tighten the screw with a 5/32 in. hex key.
•
Raise or lower the arm by turning the handwheel.
ELEVATING
SHAFT
HANDWHEEL
SCREW
SAW
BASE
LEG
STAND
t
STAR WASHER
SAW BASE
LEG STAND
3LT
FLAT
WASHER
}HER
HEXNUT
Fig. 10
21
Fig. 11
rRRFTSMRN °
RADIALSAW 315.273731
Hide quick links:
Advertisement
Table of Contents
