Multitech MultiModem II BA-Series User Manual page 134

MultiModemBA User Guide
Command
$Hn
In
I9 (2834 Series only)
L
L5
L6
L7
L8
L9 (2834 Series only)
L10 (2834 Series only)
L11 (2834 Series only)
#Ln
Mn
$MBn
* Factory Default Setting
134
Values Description
n = 1 thru 3 $H1 brings up Help Screen #1.
$H2 brings up Help Screen #2.
$H3 brings up Help Screen #3.
n = 0,1or 2 I0 requests modem ID #.
I1 requests firmware revision #.
I2 for MTS internal use.
Read Only Command enables display of Windows 95
Autodetect characteristics
Lists all stored telephone numbers in memory.
L5 lists all current operating parameters.
L6 lists all current S-Register values.
L7 lists additional parameters.
L8 lists On-Line Diagnostics.
L9 Displays Signal Strength Information.
L10 Displays Signal to Noise Ratio Information.
L11 Displays Noise Information.
n = 0 thru 3 * #L0 means modems negotiate V.42 Mode.
#L1 means MNP on and LAP-M off.
#L2 means LAP-M on and MNP off.
#L3 means no detection phase but go directly to
LAP-M.
n = 0 thru 3 M0 means Monitor speaker always Off.
* M1 means Monitor speaker On until carrier detected
M2 means Monitor speaker always On.
M3 Monitor speaker on during dialing/off during
handshaking.
n = speed 2834 Series:
$MB75 selects CCITT V.23 mode.
$MB300 selects 300 bps on-line.
$MB1200 selects 1200 bps on-line.
$MB2400 selects 2400 bps on-line.
$MB4800 selects 4800 bps on-line.
$MB9600 selects 9600 bps on-line.
$MB14400 selects 14400 bps on-line
$MB19200 selects 19200 bps on-line
$MB28800 selects 28800 bps on-line
* $MB33600 selects 33600 bps on-line
1432 Series:
$MB75 selects CCITT V.23 mode.
$MB300 selects 300 bps on-line.
$MB1200 selects 1200 bps on-line.
$MB2400 selects 2400 bps on-line.
$MB4800 selects 4800 bps on-line.
$MB9600 selects 9600 bps on-line.
* $MB14400 selects 14400 bps on-line