Configure; Quickstart; How To Use The Quickstart Page; Setup Your Gateway Using A Ppp Connection - Netopia 2200 series Software User's Manual

Configure
Button: Configure
The Configuration options are presented in the order of likelihood you will need to use
them. Quickstart is typically accessed during the hardware installation and initial configu-
ration phase. Often, these settings should be changed only in accordance with infor-
mation from your Service Provider. LAN and WAN settings are available to fine-tune
your system. Advanced provides some special capabilities typically used for gaming or
small office environments, or where LAN-side servers are involved.
☛
This button will not be available if you log on as User.
Link:

Quickstart

How to Use the Quickstart Page.

Quickstart is normally used immediately after
the new hardware is installed. When you are first configuring your Gateway, Quickstart
appears first.
(Once you have configured your Gateway, logging on displays the Home page. Thereafter, if
you need to use Quickstart, choose it from the Expert Mode Configure menu.)

Setup Your Gateway using a PPP Connection.

This example screen is the for a PPP Quickstart configuration. Your gateway authenti-
cates with the Service Provider equipment using the ISP Username and Password. These
values are given to you by your Service Provider.
Enter your ISP Username and ISP Password.
1.
48