Netopia 2200 series Software User's Manual page 228

install [ server_address ] [ filename ] [confirm]
(Not supported on model 3342/3352)
Downloads a new version of the Netopia Gateway operating software from a TFTP (Trivial
File Transfer Protocol) server, validates the software image, and programs the image into
the Netopia Gateway memory. After you install new operating software, you must restart
the Netopia Gateway.
The server_address argument identifies the IP address of the TFTP server on which
your Netopia Gateway operating software is stored. The filename argument identifies the
path and name of the operating software file on the TFTP server.
If you include the optional keyword confirm , you will not be prompted to confirm whether
or not you want to perform the operation.
license [key]
This command installs a software upgrade key. An upgrade key is a purchased item, based
on the serial number of the gateway.
log message_string
Adds the message in the message_string argument to the Netopia Gateway diagnostic
log.
loglevel [ level ]
Displays or modifies the types of log messages you want the Netopia Gateway to record. If
you enter the loglevel command without the optional level argument, the command
line interface displays the current log level setting.
You can enter the loglevel command with the level argument to specify the types of
diagnostic messages you want to record. All messages with a level number equal to or
greater than the level you specify are recorded. For example, if you specify loglevel 3, the
diagnostic log will retain high-level informational messages (level 3), warnings (level 4),
and failure messages (level 5).
Use the following values for the level argument:
228