Netopia 2200 series Software User's Manual page 114

1. WAN: Data link
activated at <Rate>
Kbps (rx/tx)
2.WAN: Data link
deactivated
3. RFC1483 up
4. RFC1483-<WAN-
instance>: IP down
5. PPP: Channel <ID>
up Dialout Profile
name: <Profile Name>
6. PPP-<WAN
Instance> down:
<Reason>
1. permitted:
2. attempt:
3. dropped - violation
of security policy:
4. dropped - invalid
checksum:
5. dropped - invalid
data length:
114
DSL Log Messages (most common):
This log message is generated when the DSL link comes up.
This log message is generated when the DSL link goes down.
This log message is generated when RFC1483 link comes up.
This log message is generated when RFC1483 link goes down.
This log message is generated when a PPP channel comes up.
This log message is generated when a PPP channel goes down. The
reason for the channel going down is displayed as well.
Access-related Log Messages
This log-message is generated whenever a packet is allowed to
traverse router-interfaces or allowed to access the router itself.
This log-message is generated whenever a packet attempts to
traverse router-interfaces or attempts to access the router itself.
This log-message is generated whenever a packet, traversing the
router or destined to the router itself, is dropped by the firewall
because it violates the expected conditions.
This log-message is generated whenever a packet, traversing the
router or destined to the router itself, is dropped because of invalid IP
checksum.
This log-message is generated whenever a packet, traversing the
router or destined to the router itself, is dropped because the IP length
is greater than the received packet length or if the length is too small
for an IP packet.