Dmt Settings; Dsl Commands - Netopia 2200 series Software User's Manual

CONFIG Commands

DMT Settings

DSL Commands

set dmt type [ lite | dmt | ansi | multi | adsl2 | adsl2+ | readsl2 |
adsl2anxm | adsl2+anxm ]
Selects the type of Discrete Multitone (DMT) asynchronous digital subscriber line (ADSL)
protocol to use for the WAN interface.
Beginning with Firmware Version 7.6, the type value also supports the following settings
on certain model units: adsl2, adsl2+, readsl2, adsl2anxm, adsl2+anxm.
☛
NOTE:
Some dmt type settings are now supported for many Annex B (335xN) plat-
forms. 2200 Series and 33xxN Series models are supported. Currently,
adsl2anxm and adsl2+anxm are not supported in Annex B.
set dmt autoConfig [ off | on ]
Enables support for automatic VPI/VCI detection and configuration. When set to on (the
default), a pre-defined list of VPI/VCI pairs are searched to find a valid configuration for
your ADSL line. Entering a value for the VPI or VCI setting will disable this feature.
set dmt wiringMode [ auto | tip_ring | A_A1 ]
(not supported on all models) This command configures the wiring mode setting for your
ADSL line. Selecting auto (the default) causes the Gateway to detect which pair of wires
(inner or outer pair) are in use on your phone line. Specifying tip_ring forces the inner pair
to be used; and A_A1 the outer pair.
set dmt metallic-termination [ auto | disabled | always_on ]
(not supported on all models) Beginning with firmware version 7.5.2, this command allows
you to apply a sealing current to "dry" DSL lines so that the wiring doesn't corrode.
247