Chapter 11 List Of Error Codes - Brother BES-1240BC Instruction Manual

Chapter 11 List of Error Codes

Code
E-00 No error occurs.
E-01 Either motor of main shaft, X- or Y-axis, or
lower shaft has locked.
E-02 Overtravel occurs during home position
detecting movement.
E-03 The stop switch is pressed during home
position detecting movement.
E-04 Zero detecting movement out of range
E-05 Needle stop position error
E-06 Needle bar case position error
E-07 Needle bar case lock
E-08 Stop switch or emergency switch was
pressed while the needle bar case is
traveling.
E-09 X-axis home position detection error
E-0A Thread breakage error
E-0B Stop or emergency stop during sewing
E-0C Insufficient bobbin thread
E-0D The machine does not return to the
home position.
E-0E Mending finish
E-14 Y-axis home position detection error
E-15 Stop key was pressed while hoop was
moving during non-sewing.
E-16 Needle with specified number sent from
PC is out of movable area.
E-17 Speed Vol. No. sent from PC is out of
range.
248
Error
BES-940BC • BES-1240BC
Measures
This is not usually displayed.
This is not usually displayed.
Turn the power off once, then on again. If the same
error occurs again, the area sensor is faulty.
Press and clear the error message. Pressing
START START
restarts the home position detecting movement again.
This is not usually displayed.
Adjust the pulley stop position (100 ) above the needle
and press .
STOP
This is not usually displayed.
Press . If the error persists, the color-change
STOP
mechanism is faulty.
Press .
STOP
Turn the power off once, then on again. If the same
error occurs again, the X-axis mechanism is faulty.
After passing through the thread, press
This is not usually displayed.
This is not usually displayed.
Turn the power off, then on again.
This is not usually displayed.
Turn the power off once, then on again. If the same
error occurs again, the Y-axis mechanism is faulty.
This is not usually displayed.
This is not usually displayed.
START START
.
STOP