Chapter 11 List Of Error Codes - Brother BES-1240BC Instruction Manual

Chapter 11 List of Error Codes

Code
E-33 Needle overhang (+X, +Y)
E-34 Needle overhang (-X)
E-36 Needle overhang (-X, +Y)
E-38 Needle overhang (-Y)
E-39 Needle overhang (+X, -Y)
E-3C Needle overhang (-X, -Y)
E-40 The status of presser foot is issued as an
alarm when every second machine is used.
E-A1 Spindle motor lock
E-A2 Main PC board temperature too high
E-A3 Spindle motor voltage too low
E-A4 Spindle motor voltage too high
E-A5 Main shaft motor CPU communication
error
E-A6 Main shaft motor CPU communication
command error
E-A7 Main shaft motor CPU send/receive
error
E-A8 Main shaft stop position signal error
E-B0 Lower shaft CPU error
E-B1 Thread tangle in rotary hook
E-B2 Lower shaft motor zero point error
E-B3 Lower shaft standby position error
E-B4 Lower shaft motor mode error
E-B5 Lower shaft communication error
E-B6 Lower shaft parameter error
250
Error
BES-940BC • BES-1240BC
Measures
Set the embroidering area again on the personal
computer or move the hoop to a sewable position.
Remove the presser foot according to the warning
instruction (to enter the every other head mode).
Set the embroidering area again on the personal
computer or move the hoop to a sewable position.
Press . If the same error occurs frequently, the
STOP
spindle mechanism is faulty.
This is not usually displayed.
Press after setting the stop position above the
STOP
pulley needle (100 degrees). If the same error
frequently occurs, the parts related to the main shaft
stop position sensor are faulty.
This is not usually displayed.
Check to see that no lint is clogged in the clearance of
the rotary hook and press
The rotary hook may be rotated forcefully. Press
to reset the error. If the same error occurs again, the
lower shaft adjustment is not proper.
This is not usually displayed.
.
STOP
STOP