Table of Contents
Advertisement
FS-2/2E FUNCTIONS
When an unknown volume type (HDD) is connected
to the FS-2/2E, the Partition process puts a FAT32
format onto the drive. It erases any previous
partition and data.
Select YES and a progress message appears on
the screen.
NOTE: You cannot add multiple partitions an a
single drive using the FS-2/2E.
With drives greater than 128G, the FS-2/2E creates
multiple partitions. There will be a partition for each
128G of disk space available.
Repair
When you make this selection, the following screen
appears:
CHECK DISK
CURRENT CLIP
EXIT
Select the desired function.
Press SEL to make a selection.
Press EXIT to return to the menu
screen.
CHECK DISK
This selection scans the entire volume for any
errors (usually, if a file was corrupted during a
recording, check disk alerts you of this).
CURRENT CLIP
This selection performs a similar function, but on
the selected clip only. If an error is found, the
FS-2/2E prompts you to repair the problem.
CURRENT CLIP repairs the last file in the current
session if it has been damaged.
2 - 32
SEL
FS-2 and FS-2E Studio DTE Disk Recorders User Guide
Part Number: MANL-0927-03
Select between volumes by pressing the
buttons. Press EXIT to return to the menu
screen.
File Name
When you make this selection, the following screen
appears:
CLIP 1-001
BASE:
20010612-166523
EXIT
This selection displays the base file name of the
selected clip.
Factory Reset
When you select this function, the FS-2/2E reverts
all settings and values back to its factory default
state.
Press YES to start factory reset.
Press EXIT or NO to exit from the
menu.
Warning: Factory Reset is not un-doable!!!
Diagnostic
When you make this selection, a screen similar to
the following appears:
DIAG LVL:
EXIT
This is a setting used for diagnosing field issues. Do
not
change
it
unless
Enhancements Technical Support.
and
:
00
told
to
by
Focus
Advertisement
Table of Contents
