Chapter 4 Reference; Technical Specifications; Input/Outputs - Focus FS-2/2E STUDIO DTE User Manual

Disk recorder
Table of Contents

Advertisement

Reference
CHAPTER 4
REFERENCE
This chapter contains reference information for the
FS-2/2E as follows:

Technical Specifications

FS-2/2E LCD Display Modes
Supported RS422 Commands
Shuttle Speed Parameters
Jog Speed Parameters
Custom Commands
Technical Specifications

Input/Outputs

Component - Y, Pr, Pb (3 x BNC in, 3 x BNC out)
if Component SMPTE:
100% white at 700mv with 300mv
Sync
700mv Chroma levels (100% color
bars)
Setup default to OFF
Chroma offset default to OFF
If Component Betacam
100% white is at 714mv with
286mv Sync
4/3 Chroma boost to 934mv p to p
Setup default to ON
If Component MII:
100% white is at 700mv with
300mv Sync
Black to White range is restricted
to 647mv (700-setup)
Setup is ON
Sync (1 x BNC in, 1 x BNC out)
Composite (1 x BNC in, 1 x BNC out)
Monitor Video Out - Composite (1 x BNC)
General Composite Specifications
Differential Phase
FS-2 and FS-2E Studio DTE Disk Recorders User Guide
2 Degree maximum
Part Number: MANL-0927-03
Differential Gain
Hue Accuracy
Signal/Noise Ratio
Bandwidth
K Factor % @ 2T
Y/C Delay
Subcarrier locking range
Subcarrier free-run frequency +/- 30 Hz (NTSC or
Genlock Horizontal
adjustment range
Residual Subcarrier
SC Phase
S-Video - Y/C (1 x 4-pin DIN in, 1 x 4-pin DIN out)
Levels Adjustments
Video Gain
- +/- 20% 2mv resolution
Chroma Gain
- +/- 20% 2mv resolution
Setup
ON adds 7.5 IRE, or 53mv to
luminance channel
OFF no change to luminance
channel
Serial Digital - SD-SDI (1 x BNC in, 1 x BNC out)
- conforms to the SMPTE 259M standard
The FS-2E outputs embedded audio in
the SDI output stream. This feature is
only available for the FS-2E.
Timecode (1 x BNC in, 1 x BNC out)
Balanced Audio (2 x XLR in, 2 x XLR out) Stereo
Audio Monitor (1 x 1/4" TRS jack)
General Audio Specifications
Balanced Inputs
Input Impedance
Ohms
Quantization
Common mode rejection @1 KHz (dB)100 dB
Analog Input adjustment range -34dB to +4.5dB (in
1.5dB steps, default setting 0dB)
Amplitude with no clipping
2% maximum
1 Degree
Greater than 54 dB
5.5 MHz
1 % maximum
Less than 25 nS
100Hz
PAL Fsc deviation
+ 4 uS
Less than 0.5 IRE
Less than 2 degrees
600
Ohms
+/-10
16 bits 48Khz
3.5Vp-p
4 - 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fs-2 studio dteFs-2e studio dte

Table of Contents