Cf_Inputsearch Command; Cf_Autosetuppcadj Command; Cf_Autosetupkeystone Command; Cf_Autosetup Command - Sanyo PLC-XK2200 - 2200 Lumens Manual

PLC-XK2200 /2600 /XK3010

8.10.3 CF_INPUTSEARCH Command

Command "CF_INPUTSEARCH_%1"[CR]
"OFF" ------------------------- Set Input search operation to OFF
%1 "ON1" ------------------------- Set Input search operation to On1
"ON2" ------------------------- Set Input search operation to On2
Set Input search operation mode.
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
Details This command is available in normal Power ON status.
Note) It is unable to set Keystone, PC ADJ. and Input search to OFF at once.
e.g. If projector receives Input search OFF command while Auto PC ADJ. and
Keystone are OFF, it returns error code "101"..
Acceptable
Response
Unacceptable

8.10.4 CF_AUTOSETUPPCADJ Command

Command "CF_AUTOSETUPPCADJ_%1"[CR]
"ON" ------------------- Set Auto PC ADJ. function to ON
%1
"OFF" ------------------ Set Auto PC ADJ. function to OFF
Set/Cancel Auto PC adj. function
This command is available in normal Power ON status.
Details Note) It is unable to set Keystone, PC ADJ. and Input search to OFF at once.
e.g. If projector receives Auto PC ADJ. OFF command while Keystone and Input
search are OFF, it returns error code "101".
Acceptable
Response
Unacceptable

8.10.5 CF_AUTOSETUPKEYSTONE Command

Command "CF_AUTOSETUPKEYSTONE_%1"[CR]
"AUTO" ------------------- Set Auto Keystone function to Auto
%1 "MANUAL" --------------- Set Auto Keystone function to Manual
"OFF" --------------------- Set Auto Keystone function to OFF
Set Keystone function of Auto setup
This command is available in normal Power ON status.
Details
Note) It is unable to set Keystone, PC ADJ. and Input search to OFF at once.
e.g. If projector receives Keystone OFF command while Auto PC ADJ. and Input
search are OFF, it returns error code "101"..
Acceptable
Response
Unacceptable

8.10.6 CF_AUTOSETUP Command

Command "CF_AUTOSETUP_%1"[CR]
%1 "START" ------------------- Execute Auto Setup
Execute Auto Setup
Details Note) CF commands does not execute while Auto setup is in process. If the
command is sent during this, projector returns error code "302"
Acceptable
Response
Unacceptable
Expand Serial Command Functional Specifications
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
38 / 73