Pc Adjust Control Command; Cf_Fsync Command; Cf_Tdots Command; Cf_Clamp Command - Sanyo PLC-XK2200 - 2200 Lumens Manual

PLC-XK2200 /2600 /XK3010

8.5 PC Adjust Control Command

8.5.1

CF_FSYNC Command

Command "CF_FSYNC_%1"[CR]
"0000~0031" --------------- Directly select Fine Sync setting value
%1 "UP" -------------------------- Current Fine Sync setting value + 1
"DN" -------------------------- Current Fine Sync setting value - 1
Set Fine Sync value of PC signal
Projector does not save the value set with this command so that it resets when
Details
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.2

CF_TDOTS Command

Command "CF_TDOTS_%1"[CR]
"mmmm~nnnn" --- Directly select Total Dots setting value
"mmmm" shows minimum value, it is current Display Dots Horizontal value +
Position value
%1
"nnnn" shows maximum value, which is not over 140MHz.
"UP" -------------- Current Total Dots setting value + 1
"DN" -------------- Current Total Dots setting value - 1
Set Total Dots of PC signal
Projector does not save the value set with this command so that it resets when
Details
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.3

CF_CLAMP Command

Command "CF_CLAMP_%1"[CR]
"mmmm~nnnn" ---- Directly select Clamp setting value
"mmmm" shows minimum value, fixed-value "0001".
%1 "nnnn" shows maximum value: it depends on input signal.
"UP" ------------------ Current Clamp setting value + 1
"DN" ------------------ Current Clamp setting value – 1
Set Clamp value of PC signal
Projector does not save the value set with this command so that it resets when
Details
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
Expand Serial Command Functional Specifications
"000"[CR]
"Error Code"[CR]
.
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
23 / 73