Other Status Read Command; Cr_Status Command; Cr_Signal Command; Cr_Vmute Command - Sanyo PLC-XK2200 - 2200 Lumens Manual

PLC-XK2200 /2600 /XK3010

9.12 Other Status Read Command

9.12.1 CR_STATUS Command

Command "CR_STATUS"(CR)
Get status of Projector behavior.
Details This command affects the same as "CR0" of Basic Serial command, but this has
an error code.
Acceptable
Response
%1
Unacceptable

9.12.2 CR_SIGNAL Command

Command "CR_SIGNAL"(CR)
Details Get Signal status if there is signal or not
Acceptable
Response
%a
Unacceptable

9.12.3 CR_VMUTE Command

Command "CR_VMUTE"[CR]
Details Get setting status of No Show
Acceptable
Response
%a
Unacceptable

9.12.4 CR_FREEZE Command

Command "CR_FREEZE"[CR]
Details Get setting status of Freeze
Acceptable
Response
%a
Unacceptable
Expand Serial Command Functional Specifications
"000_%1"[CR]
"00"= Power ON
"80"= Stand by
"40"= Count down
"20"= Cooling down
"10"= Power failure
"28"= Cooling down due to abnormal temperature
"88"= Stand by after Cooling down
"24"= Power saving cooling down
"04"= Power saving
"21"= Cooling down due to Lamp failure
"81"= Stand by after Cooling down due to Lamp failure
"Error Code"[CR]
"000_%a"[CR]
"ON" ------------------------ Signal is found
"OFF" ----------------------- There is no signal
"Error Code" [CR]
"000_%a"[CR]
"ON" -------- No Show is ON, User Logo (My picture) is displayed
"OFF" ------- No Show is OFF
"Error Code" [CR]
"000_%a"[CR]
"ON" ---------------------- Freeze is ON
"OFF" --------------------- Freeze is OFF
"Error Code" [CR]
70 / 73