Pioneer PD-R555RW Operating Instructions Manual page 109

Symptom
Power cannot be turned on.
Playback is impossible.
Recording is impossible.
Recorded sound is distorted.
Remote control operation is
impossible.
Certain tracks are skipped
without being played.
Skip playback does not occur.
A recorded CD-R disc cannot
be played on other CD
players.
The point-of-sale
demonstration is displayed.
(Note)
(Note) This displays certain characters, like PIONEER, SKIP, and PROGRAM, as a point of sale demonstration.
Cause
The power cord is unplugged from the power
outlet.
The power was turned off from the component
(stereo amplifier, audio time, etc.) to which it is
connected.
Signal connections are incorrect.
Signal connections are incorrect.
The CD-R or CD-RW disc in use has been finalized.
The input selection is incorrect.
The REC LEVEL control is set too low.
Signal connections are incorrect.
There is interference from a TV set.
The recording level is set too high.
The disc is damaged or warped.
The disc is extremely dirty.
The remote control batteries are exhausted.
There is an obstacle between the remote control
unit and main unit.
The remote control unit is operated outside the
remote controllable range.
The SKIP PLAY button is set to ON.
The SKIP PLAY button is set to OFF.
÷ The disc has not been finalized after
recording.
÷ When such a disc is loaded in the unit, the
CD-R indicator lights up. (Refer to page 16.)
÷ The pickup lens of the other
dirty, impairing its ability to play
The demonstration mode can be initiated by
pressing the 4 1 button when the display
goes on and the disc is read after turning on the
power before timer play starts. (When no disc is
provided, press the 4 1 button immediately
after "00 00:00" has appeared on the display.)
(Activating the demo mode.)
Plug the power cord into a power outlet.
Turn on the component into which the power
cord is connected.
Connect properly as indicated in "CONNEC-
TIONS".
Connect properly as indicated in "CONNEC-
TIONS".
Use a non-finalized disc. Erase a CD-RW disc.
Select the input connected to the desired
source.
Increase the recording level to an optimum
level.
Connect properly as indicated in "CONNEC-
TIONS".
Turn the TV power off or install this unit apart
from the TV.
Decrease the recording level.
Use another disc.
Clean the disc.
Replace both of the remote control batteries
with new ones.
Remove the obstacle.
Operate in the remote controllable range.
Set the SKIP PLAY button to OFF.
Set the SKIP PLAY button to ON.
÷ Finalize the disc. (Refer to page 74.)
÷ Try the disc on a different
player is
CD
– discs. plays then get the pickup lens on the
CD R OK
original player cleaned.
To cancel the demonstration mode, press the
¡ ¢ button when the display goes on and
the disc is read after turning on the power before
timer play starts. (When no disc is provided,
press the ¡ ¢ button immediately after "00
00:00" has appeared on the display.) The
demonstration will not be displayed any more.
Remedy
player. If it
CD
109
<PRE1269>
Ge/It En