Advertisement
STEP 1
: (Figure 1)
Identify and position the right base bracket as shown.
Attach the right base bracket to the front holes of a base
leg tube. Make only finger tight.
Repeat for the left base
bracket.
STEP 2:
(Figure 2)
Insert the ends of the base leg tubes into the upper base
tube (supplied with the Sun Shade).
BASE LEG TUBE
(ROUND END)
SPACER
5/16" x 2-3/4"
CARRIAGE BOLT
5/16" NYLOCK
NUT
J
LEFT BASE
BRACKET
\
RIGHT BASE BRACKET
FIGURE 1
UPPER BASE TUBE
\
BASE TUBE LEGS
FIGURE 2
STEP 3:
(Figure 3)
Raise the tractor seat and remove the springs and bolts
from the rear fender
STEP 4:
Place the base tube assembly onto the rear fender.
Check for clearance with the seat lowered and the rear
bagger (optional) attached. If needed, reposition the base
brackets to a different set of holes in the base tubes.
STEP 5:
(Figure 3)
Attach the seat springs and the base brackets to the rear
fender. On LT tractors use the bolts that you removed. On
GT tractors, if the bolts removed were less than 1" long,
use 5/16" x 1" bolts and 5/16" washers from the parts bag.
Align the base leg tubes on the rear fender. Tighten with
moderate force.
\\\
ORiGiNAL
BOLT
OR 5/16" x 1" BOLT
_"
AND 5/16" WASHER
__
ADJUST
TO FiT
FIGURE
3
STEP 6:
(Figure 4)
If the base tubes rest down against the top of the fender,
install the rear base support brackets. Attach an adhesive
pad to the bottom of each bracket then attach the brackets
to the appropriate holes in the base support tubes. Adjust
the brackets to lift the base tubes above the fender, then
tighten.
STEP 7:
Tighten the bolts assembled in step 1.
STEP 8:
Continue with step 10 in your Sunshade manual.
5/16" NYLOCK NUT
REAR SUPPORT BRACKET
5/16" × 2"
CARRIAGE BOLT
ADHESIVE PAD
2
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
