Carrier Expressions 38CS030 Owner's Manual page 4

INFRARED SIGNALTRANSMITTER WINDOW
CLOCK-_-_
SENSOR
INDICATOR
TIMER START/STOP
ONE-TIME/DAILY INDICATORS
MODE BUTTON
OPERATION MODE INDICATORS -
COOLING, FAN, HEATING,
DEHUMIDIFICATION AUTO
FAN INDICATORS -
LOW, MEDIUM, HIGH, AUTO
TIMER SET BUTTONS*
SLIDE DOWN PANEL
-- LOW BATTERY INDICATOR
UP/DOWN BUTTON
SENSOR ACTIVE INDICATOR
SWEEP INDICATOR
ROOM TEMPERATURE BUTTON*
BUTTON*
LOCAL SENSING BUTTON
UNIT
REMOTE
*Buttons located behind slide down panel.
Fig. 4- Remote Control
PROGRAMMING TIME PERIODS The duct fi'ee sys-
tem can be progralrnned to operate at desired levels. Be sure to
set the clock before pro_alrnning the system.
• Increments of time are in 10 minute intervals.
• The Timer Start/Stop indicator light on the unit is on
when a time period is set. See Fig. 4.
• The remote control displays the Start/Stop time of the
time period that is closest to the current time. If the unit
is ON, "STOP" and the time period is displayed. If the
unit is OFF, "START" and the time period is displayed.
IMPORTANT: Be sure to point the remote control ]
toward the unit ,ahite pressing the TIMER or SET
I
buttons.
Settin_ Start/Stop Time Timer feature is used to set unit
operation Start/Stop times. Three difl'erent time periods up to
10 hours apart and within 24 hours can be progralrnned using
this l_ature.
1. Slide down fiont cover of controller below ON/OFF but-
ton. See Fig. 4.
Fig. 5 -- Location of Clock Set Button
on Remote Control