Side Floor Frame; Ramp - Arrow BY1012-A Owner's Manual & Assembly Instructions

08934 Ramp (1)
L_Lpi_'1_'e_'_Jl @ Parts Needed For @ ® 9367 Front FIoor Frame (2) Floor Frame Assemblies ®893s R ear F oor F rame ( 2)
@ 10392 Side Floor Frame (4)
SVI4
The front floor frame is made up of
three pieces. The side floor frames
and the rear floor frame are made up
of two pieces. The holes in these
pieces will align when the pieces are
positioned with correct amount of
overlap. The illustrations below show
the proper overall length for the sides,
rear and front. Proceed as follows:
....
8934
9367
8936
1 Place the front floor frames as
shown. Center the ramp, with drain
holes facing outside, on top of the two
front floor frames. Join the frames by
inserting eight screws.
2 Overlap the side floor frames and
the rear floor frames as shown. The
holes in these pieces will align when
the pieces are positioned with cor-
rect amount of overlap. See the illus-
trations below for the proper overall
length of the side and rear floor frames.
Join the frames by inserting four/five
bolts into each frame set as shown.
:3 Double check the length of each
and set these pieces aside for later
use.
_'9' 99 Front Floor
9_ 8934 9'!1'1! Frame Assembly
1193/8" 3,0m
L Yff_
9367 ! 11! .AIIII_. _,tI 9367
-- ' DRAIN HOLES FACE<_ '"'
OUTSIDE
9cite
10392 _l, I lI
Side Floor Frame 141 5/8" 3,6m
eoe_ !_e_e
1t9 I
I ]_,', L
Rear Floor Frame 119 3/8"
3,0m
;-" 8936 [ ! ',1 ', _ 8936
14