Connecting Signal Cables; Inputting Image From Main To Sub; Inputting Image To Sub And Main Individually - Hitachi CP-X8150 User Manual

4.2 Connecting signal cables

There are two methods to input image to the Sub projector. ( 18, 19 )
- Inputting image from the MONITOR OUT port on Main to Sub.

- Inputting image to Sub and Main individually.

Inputting image from Main to Sub

1.
Connect the MONITOR OUT port on Main
to the COMPUTER IN1 port on Sub with a
computer cable.
2.
Connect the image output device to one of
the input ports on Main.
NOTES for Intellectual Stack
• COMPUTER IN1 and IN2 can be used
as the input port for the Main projector in
Intellectual Stack. Do not use other ports for
image input.
- You can input component signals to
COMPUTER IN1 and IN2.
- You can input video signals to the Y pin of
the component video of COMPUTER IN1 and
IN2.
NOTES for Simple Stack
• COMPUTER IN1 and IN2 can be used
as the input port for the projector that is
connected with a computer cable at its
MONITOR OUT port.
→ SETUP menu) If you wish to use other
input ports, input the image to Sub and Main
individually.
Inputting image to Sub and Main individually
1.
Split the output signal from your image device into two with device such as a
signal splitter.
2.
Connect the output ports of the image output device to the same input ports
on the Main and Sub projectors.
NOTES for Intellectual Stack • LAN, USB TYPE A and USB TYPE B
cannot be used as the input ports on the Main projector in Intellectual Stack.
NOTES for Simple Stack • Any of the ports that is compatible with the
signal can be used. Input the same signal to the two projectors individually.
(Operating Guide
Main
Sub
24
Connecting cables
Connection example
in Intellectual Stack