Setting Upanynet - Samsung HL61A750A1FXZA Getting Started Manual

Setting Up Anynet +
The following settings help set the Anynet + functions.
To use the An net+ Function An net+ HDMI-CEC) must be set to On
1 Press the MENU button. Press the A or _r button to select Application, then
press the ENTER button.
2 Press the A or T button to select Anynet+ (HDMI-CEC), then press the
ENTER button.
Press the A or _' button to select On, then press the ENTER button.
The Anynet+ (HDMI-CEC) function is enabled.
if you select Off, Anynet+ (HDMI-CEC) is disabled.
When the Anynet+ (HDMI-CEC) function is disabled, all the Anynet + related
operations are deactivated.
Settin_net+ Device to turn Off Automaticall_L when the TV is Turned Off
2 Press the A or T button to select Auto Turn Off, then press the ENTER button.
3 Press the A or T button to select Yes, then press the ENTER button.
The Auto Turn Off function is enabied.
If you seiect No, the Auto Turn Off function is canceled.
Press the EXiT button to exit.
The active source on the TV remote must be set to TV to use the Anynet + function.
If you set Auto Turn Off to Yes, sconnected external devices are also turned off when the TV is turned off.
If an externa! device is still recording, it may or may not turn off.
Scanning and Switching between Anynet + Devices
Press the TOOLS button.
Anynet + devices connected to the TV are listed.
If you cannot find a device you want, press the red button to scan for
devices.
2 Press the A or _r button to select a particular device and press the ENTER
button. It is switched to the seiected device.
Only when you set Anynet+ (HDMI-OEC) to On in the Application menu,
the Device List menu appears.
3 If you cannot find a device you want, press the A or _' button to seiect
Searching Connections, then press the ENTER button.
The message Configuring Anynet + connection.., is displayed.
When searching devices complete, the connected devices are listed in the
Anynet+ menu.
_'_ Switching to the selected devices may take up to 2 minutes. You cannot cancel the operation during the switching
operation.
The time required to scan for devices is determined by the number of connected devices.
_,_ When the device scan is complete, the number of devices found are not displayed.
Although the TV automatically scans devices when it is turned on using the POWER button, devices connected when
the TV is already on are not displayed in the device list. In this case, select the Searching Connections menu to search
devices.
If you have selected an external device by pressing the SOURCE button, you cannot use the Anynet + function. Make
sure to switch to an external Anynet + device by using the TOOLS button.
Continued...