Ctrl/Download Button; Xv400; Xv100; File System - Micro Innovations Windows CE Manual

Windows CE
1.5 CTRL/DOWNLOAD
1.5.1

XV400

The CONTROL button on the device has two different functions:
1. If the button is pressed on startup, the bootloader will list all directories and files on the Compact
Flash card. This can be useful when analyzing problems. Windows CE is then started in the usual
manner.
2. If the button is held down during the Windows CE startup (after the bootloader), the
and Autoexec.reg files are not run.
Note:
The button is labeled depending on the MICRO PANEL either with CTRL or DOWNLOAD.
See also chapter Startup
1.5.2

XV100

The CONTROL button on the device has three different functions:
1. If the button is pressed on startup and held down for at least 3 seconds, the device with the
firmware OS is started irrespective of which device was defined as boot device.
2. If the button is held down during the Windows CE startup (after the bootloader, i.e. "Launch OS at
800F1000h" was displayed), the files
3. If the button is pressed on startup and is released after the display of "Pressed button detected",
the "Debug mode active!" state is set which is required for developing the device.
1.6 F
ILE SYSTEM
The file system on the device has a structure similar to the following:
In the above example, an
afterwards from the PC using Microsoft Windows® Explorer.
M000174-19
BUTTON
behavior, Autoexec.reg,
Autoexec.bat
ActiveSync connection
Autoexec.bat and Autoexec.bmp
and Autoexec.reg
was created and the file system was then viewed
General
Autoexec.bat
are not run.
11