Adjusting The Tracking - Epson EMP-52 User Manual

Adjusting the Image Quality
• If you press the [Auto] button while the E-Zoom or Freeze function is being used or
while a configuration menu or help menu is being displayed, the function will be
cancelled when you press the [Auto] button, and then the adjustment will be carried
out.
• Sometimes the signals may not be adjusted correctly depending on the type of signals
being output by the computer. In such cases, use the configuration menu commands to
adjust the tracking and sync settings manually. (p.38, 39)

Adjusting the Tracking

If vertical stripes appear in the projected
images, and this cannot be fixed using
automatic setup, you will need to adjust the
tracking manually using the following
procedure.
Procedure
1
Press the [Menu] button on the
remote control, and then select
"Tracking" from the "Video"
menu.
For details on this operation, refer to
"Using the Configuration Menus".
(p.56)
2
Press the [ ] and [ ] buttons
to set the tracking value.
The tracking value increases or
decreases each time a button is
pressed.
3
After making the adjustment, press the [Menu] button to exit
the configuration menu.
Tip :
The image will flash when continuous tracking adjustment is carried out, but this is
normal.
Video Position
Audio
Tracking
Setting
Sync .
Advanced Brightness
Contrast
About
Reset All Sharpness
Color Mode
Input Signal
Auto Setup
Reset
: Return : Select : Adjust
Video Position
Audio Tracking
Setting Sync .
Advanced Brightness
Contrast
About
Reset All Sharpness
Color Mode
Input Signal
Auto Setup
Reset
: Return : Select : Adjust
38
Adjust
0000
:
: 0
-
: 0 +
: -
0 +
: 0 - +
Select [Normal ]
:
RGB
YUV( YCbCr YPbPr)
:
ON OFF
Execute
Adjust
: 1000
: 0
: 0 -
+
:
0 -
+
: 0 -
+
Select [Normal ]
:
RGB YUV( YCbCr YPbPr)
:
ON OFF
Execute