TOOLS AND MATERIALS REQUIRED
1.
2.
3.
4.
5.
6.
1.
Tools
Anti-Static Field kit. It is recommended that an anti-static field kit be kept on any
site where solid-state printed circuit boards and other ESD-sensitive compo-
nents are handled. These kits are designed to remove any existing static charge
and to prevent the build-up of a static charge that could damage a PC board or
ESD-sensitive components. The typical anti-static field kit consists of the
following components:
1.
2.
3.
4.
Toothbrush (any standard one will do)
TABLE OF CONTENTS
TOOLS AND MATERIALS REQUIRED
A work surface (10mm conductive plastic sheet with a female snap
fastener in one corner for ground cord attachment).
A 15-foot long ground cord for grounding the work surface.
Wrist strap (available in two sizes, large and small, for proper fit and
comfort) with a female snap fastener for ground cord attachment.
A coiled ground cord with a practical extension length of 10 feet for
attachment to the wrist strap.
ESDS Manual
S14006
4/15/92
PAGE
1
2
2
3
5
6
8
10
1