Operation Procedure When Executing Particular Operation - Konica Minolta bizhub C451 Operation Manual

Operation procedure when executing particular operation

1. When using the License already activated on the other MFP (Refer to fig. below),
a. Deactivate the License on the MFP A.
b. After the deactivation made on MFP A, it is possible to activate the License again on
MFP B.
Do not execute Initialization for this purpose, especially on the MFP with License
activated. (MFP A) (Please make sure to execute Deactivation.) If executing
Initialization, the following operation is required to transfer the License to the other
MFP.
i. Activate the License on MFP A once. (The License needs to be activated on
MFP A.)
ii. Deactivate the License. Then it is possible to use deactivated license on
other MFP B.
a
License
Deactivation
MFP A
2. When replacing NVRAM for a new one,
If replacing NVRAM, please make sure to use the new one.
License Management error will occur. The following operation is required to solve that
error.
If the license is activated,
a. execute Repair
b. execute Activation after Repair
If the license is NOT activated,
a. execute Repair
b. If Repair is not completed correctly, then execute Initialization.
Issued by BT-CSO
Transfer
b
License
Activation
67
for Customer Engineer
MFP B
Ver 1.03