Feeder pre-registration clutch
1.
Remove the paper feeder.
2.
Remove the feeder registration chute.
3.
Turn over the paper feeder and disconnect the wiring harness from the
feeder pre-registration clutch.
4.
Remove the two screws securing the feeder pre-registration gear
assembly to the paper feeder. Remove the gear assembly.
5.
Remove the E-rings securing the feeder pre-registration clutch and the
pre-registration gear to the pre-registration support. Remove the
support.
6.
Slide the feeder pre-registration gear off the shaft.
7.
Undress the J95 wiring harness and slide the feeder pre-registration
clutch off the feeder pre-registration shaft.
Removing the feeder pre-registration clutch
88
Phaser 780 Color Printer
P/J95
Pre-registration
gear assembly
Pre-registration
clutch
Pre-registration
gear
Pre-registration
support
780-5-39