Warning Screen; Advanced Settings Screen - Dukane iQ Series HP User Manual

iQ Series,
Ultrasonic Hand Held Systems User's Manual
Advanced Settings
3.
After Advanced Settings is selected, a warning screen
is displayed as shown in Figure 5-13.
Adjusting these settings may affect the operation of
your unit. Before you change a setting, please check
with Dukane personnel for their recommendations.
The warning screen is shown for a few seconds, then,
the Advanced Settings screen appears.
See Figure 5-14.
Adjustments can be made to:
;
Ramp Up Time Frequency Lock and Hold
, but note that Trigger by Power is only
ger By Power
available when the weld mode is time or energy.
Free Run Frequency
Free run is the frequency at which the generator
drives the ultrasound ouput pulses until a valid
feedback signal is detected. Typically this value
should be below the operating frequency of the
probe.
Follow the on screen prompts to make setting
adjustments.
Ramp Up Time
This parameter increases the amplitude linearly in
the programmed time period at the start of the weld
from zero to the programmed amplitude level. This
brings the probe up to operating amplitude smoothly
preventing shock stress.
Follow the on screen prompts to make setting
adjustments.
Lock and Hold
For an explanation of Frequency Lock and Hold,
please refer to Application Note 505 found on our
website at:
http://www.dukane.com/us/DL_ApplData.asp
Follow the on screen prompts to make setting
adjustments.
Page 
Continued
Free Run Frequency
; and,
Continued
Modified settings
may affect operation
Figure 5-13 Warning Screen
Trigger by Power is only avail-
;
able when the weld mode is
Trig-
either Time or Energy.
Free Run Freq
Ramp Up Time
Lock and Hold
>
Trigger By Power
Press Enter To Accept
Press Cancel To Abort
Figure 5-14 Advanced Settings Screen
Warning
of this unit!
NOTE
Advanced Settings
19900Hz
150mS
ON
ON
Dukane Manual Part No. 403-577-01
OFF
OFF