Directed Electronics ProSecurity RK20 Installation Manual page 20

Remote start keyless entry

Table of Contents

H1/7

RED/WHITE

This wire produces a (-) 200mA output for progressive locks in which the driver

door unlocks first and the remaining locks unlock with a second press of the

unlock button.

H1/8

BLACK

Remove any paint and connect this wire to bare metal, preferably with a fac-

tory bolt rather than your own screw. (Screws tend to either strip or loosen with

time.) We recommend grounding all your com po nents to the same point in the

vehicle.

CHANNEL 2, (-) 200mA OUTPUT

Warning! Never use this wire to drive anything

but a relay or a low-current input, supplied out-

put is only 200mA. Connecting directly to a

solenoid, motor, or other high-current device

will cause the module to fail.

(-) CHASSIS GROUND CONNECTION

Table of Contents