Internal Programming Jumper; Zones - Directed Electronics AM1 Installation Manual

internal programming jumper

A 10A fuse is used as both a fuse and a program jumper. This jumper determines the
light flash output polarity. In the (+) position, the on-board relay is enabled and the
unit will output (+)12V on the WHITE wire, H1/2. In the (-) position, the on-board
relay is enabled for (-) output on the WHITE wire, H1/2. To access the jumper, remove
the sliding door from on top of the control module, as shown below.

zones

Zone
Trigger Type
Number
1 Instant trigger
2 Multiplexed input
3 Two-stage, progresses from warning
to full alarm
4 Multiplexed
5 Two-stage (similar to zone 3)
N N O O T T E E : : The Warn Away
24
FUSE/JUMPER
(-) POSITION
Input Description
Hood and/or trunk pin switches.
Heavy impact from on-board
Doublegurard
Door switch circuit.
Optional sensor, Inputs shorter than
0.8 seconds will trigger Warn Away
response, while inputs longer than
0.8 seconds will instantly trigger full
alarm.
Ignition input.
response does not report on the LED.
®
FUSE/JUMPER
(+) POSITION
® shock sensor.
© 2005 directed electronics, inc.
®