Datalogic GRYPHON Dx30 Reference Manual page 173

TECHNICAL FEATURES
GRYPHON™ Dx30/Mx30 READER DATA ENTRY
¹ LED
Beeper
ON
one beep²
H L long
H long ON
H H H
H H long
OFF
GRYPHON™ Mx30 POWER
Beeper
10 short H
GRYPHON™ Mx30 BIND, JOIN, COPY COMMANDS
¹
Beeper
L
H L long tones
¹ Only the Beeper Intensity command can modify these signals.
² The data entry good read tone is user-configurable with all the Beeper commands
in the Reading Parameters section.
For Mx30 series readers, normally this results in two beeps; the first indicates that
the reader has decoded the code, the second indicates whether OM-Gryphon™
has received the data. See also par. 5.7.3.
Good Read Spot Meaning
ON
ON
OFF
LED Meaning
10 short blinks Low Battery
LED Meaning
Blinking Command accepted; reader ready to be inserted into
the cradle
Success
Failure
Correct read of a code in normal mode
TX buffer full (when FIFO is enabled) or TX
error between
OM-Gryphon™
Successful advanced format concatenation
Timeout expired – operation not completed
Error in advanced data formatting
Ready to read a code
Gryphon™ Mx30
6
and
163