Inter-Block Delay; Data Format; Header/Terminator Selection - Datalogic GRYPHON Dx30 Reference Manual

5
5.2.5

Inter-Block Delay

For the PEN Emulation interface, data are sent to the Host in fixed size blocks of 20
characters each. The inter-block delay parameter allows setting a delay between
each block sent to the Host.
5.3

DATA FORMAT

The system always provides gun to host data communication using the following
message formatting:
Output Message from Gryphon™ Dx30 or Gryphon™ Mx30 Stand Alone Towards
[Header] [Gun_Addr] [Gun_Addr_delimiter] ] [Code ID] [Code Length]
[Terminator]
Output Message from Gryphon™ Mx30 STAR-System™ Towards Host
[Header] [Code ID] [Code Length]
5.3.1

Header/Terminator Selection

The header/terminator selection is not effected by the reading of the restore default
code. In fact, header and terminator default values depend on the interface selection:
RS232:
WEDGE:
These default values are always restored through the reading of RS232 or WEDGE
interface selection code, see chapter 2.
138
Host
[Items in square brackets are optional.]
[Items in square brackets are optional.]
no header, terminator CR-LF
no header, terminator ENTER
GRYPHON™ Dx30/Mx30
CODE
[Terminator]
CODE