Radio Parameters (Mx30 Series Only); Radio Protocol Timeout; Power-Off Timeout; Beeper Control For Radio Response - Datalogic GRYPHON Dx30 Reference Manual

REFERENCES
5.7

RADIO PARAMETERS (MX30 SERIES ONLY)

5.7.1

Radio Protocol Timeout

This parameter sets the valid time to wait before transmission between the Mx30
series reader and OM-Gryphon™ cradle is considered failed.
This parameter should be set taking into consideration the radio traffic (number of
readers in the same area).
If the RS232 interface is used with ACK/NACK enabled, this parameter should be at
least equal to the RX Timeout parameter for low traffic environments. It should be
increased if there are many readers in the same area.
It can be set between 2 and 19 seconds.
5.7.2

Power-Off Timeout

If this command is enabled, after the desired timeout in hours, the Gryphon™
batteries are disconnected and all power consumption ceases. To restore power,
press the trigger once. The reader will now be ready to read codes.
Power-off does not effect configuration parameters.
5.7.3

Beeper Control for Radio Response

For Mx30 series readers, the data entry good read tone normally results in two
beeps; the first indicates that the reader has decoded the code, the second indicates
whether OM-Gryphon™ has received the data.
This can be changed according to the following selections:
♦ Normal: both good decode and good reception are signaled (two beeps).
♦ Only Good Decode: only the first beep indicating a good read is signaled.
♦ Only Good Reception: only the second beep indicating a good reception is
signaled.
♦ Off: Neither good read nor good reception beeps are signaled.
For all configurations, any transmission errors will always be signaled.
5
151